15
2. Speed control with touch function: The motor handpiece can be run at the preset speed
by a single touch of the operating lever.
To activate the speed control function, proceed as follows:
Please always observe the maximum permitted speed for your tools!
1.
1. Press to activate the simple speed control function.
The speed control is now active. If a selected speed is held for more than 2 seconds, this speed is saved to
the memory and the operating unit (knee pad etc) is no longer needed. To stop, touch the operating unit
once
1.
1. Press to activate speed control with touch function.
Speed control with touch function is now active. Once the control unit is pressed, the handpiece
starts at the preset speed on the control satellite.
11.3 Speed control with touch function
12. Connecting and controlling a second motor handpiece (only with
Premium)
The
Premium control unit enables a second motor handpiece to be connected. For this purpose,
a second
hand piece or a hand piece from the Profi, Junior or C Master ranges that can
be connected using an adaptor cable (obtainable from Schick), would be suitable.
The handpieces can only be operated individually and not in parallel!
11.2 Simple speed control
The motor handpiece can be operated using the speed control function without having to
continuously press the control unit.
Two different speed controls can be used via the controls satellites.
1. Simple speed control: speed is maintained without pressing the control lever further as soon
as the speed has been held constant for longer than 2 seconds
11. Speed control function
