B1051101 Rev. –
PC-1000 Installation
14
4. Remote Module, Power Supply, and PCI Board
4.1 Install Remote Module
4.1.1 Tools and Materials
To install the remote module, you will need velcro patches to secure the module to the
top of the panoramic machine, and a screwdriver to secure the sensor cable connector to
the remote module.
4.1.2 Step-by-Step
Instructions
NOTE: Before applying velcro patches, clean the
surface area to ensure good adhesion.
A.
Apply velcro to the top of the panoramic machine, along the top edge of the rotational
arm. This will make it easy to see the status lights on the module.
B.
Apply velcro to the bottom of the remote module also, and mount the remote module
to the panoramic machine.
C.
Connect the sensor cable to the remote module. Then, use a small screwdriver to
tighten the screws on the 37-pin connector.
