PC-1000 Installation
B1051101 Rev. –
1
1. Introduction
1.1 Welcome
The CDR Panoramic X-ray System (“CDRPan”) is an electronic imaging system that
integrates with panoramic machines to acquire, display, store and print digital X-rays.
Because of its digital format, the X-ray can be enhanced for more detail using CDR tools,
and it can be archived for patient histories and retrieved for comparisons.
1.2 CDRPan System
The CDRPan system hardware consists of the following components (unless otherwise
indicated, all part numbers (P/Ns) refer to Schick Technologies numbers):
•
CDRPan kit for Panoramic Corp. PC-1000 (P/N B4770050), which includes
the sensor, codestrip, other attaching parts, and accessories
•
Remote module (P/N B4750100)
•
Power supply (P/N A3302300)
•
PCI board (P/N B3301100) and cable (B2211001).
The CDRPan system requires the following software:
•
CDR software (version 2.1 or higher)
•
CDRPan software, which includes the PCI board device driver and the series
set to be used with panoramic exams
1.3 Overview for Installing CDRPan
This Installation Manual is one of two documents you will need to install the CDRPan
system completely. After performing the installation procedure in this document, you
should refer to the CDRPan User’s Guide (P/N B1051008) to install the software for the
CDRPan system. Procedures for installing CDRPan system hardware and software can be
found in the following documents.
PROCEDURE
DOCUMENT
Install Sensor and Codestrip
(This Manual)
Install Remote Module and Power Supply
(This Manual)
Install PCI Board
(This Manual)
Install PCI Device Driver
CDRPan User Guide
Install CDR and CDRPan Software
CDRPan User Guide
