B1051039 Rev. B
USBCam
6
3.3. Installing CDR Software
PLEASE NOTE: If you have already installed CDR software on your system, skip ahead
to the CDR Video Manager, DirectX update, and device driver installation procedures that
apply to your operating system.
CDR software is an essential component of every CDR system. When you receive your
CDR software, follow the short directions below to load the CDR program.
Turn on your computer (if it’s not on already), wait for the Windows desktop, and insert
the CD. The CD should install the CDR setup program automatically. If it doesn’t, click
the
Start
button and then on
Run.
When the Run dialog box opens, type
d:\cdrsetup\setup
(if “d” is the drive letter for your CD-ROM drive. If your CD-ROM
drive uses a different letter, type in that one instead). Then read and follow the instructions
on each screen. When you’re all done, remove the CD and restart your computer.
Continue with the steps provided in the following paragraphs to install the CDR Video
Manager for DirectX, update your DirectX files, and install the USBCam device drivers
for your particular operating system.
