Angled Flashing
Manufactured in stainless steel for use on pitched roofs�This item is used in conjunction with the Metaloterm storm collar, which is
purchased separately� The storm collar should be positioned immediately above the cone of the flashing, leaving a gap large enough
to allow for ventilation, whilst ensuring that the cone is protected from rain ingress� The joint between the storm collar and the outer
case of the flue should then be sealed with a mastic sealant, which is purchased separately�
Flat Flashing
Manufactured in stainless steel for use on flat roofs the base of the flashing should be covered by the roofing felt and then sealed�
TThis item is used in conjunction with the Metaloterm storm collar, which is purchased separately� The storm collar should be
positioned immediately above the cone of the flashing, leaving a gap large enough to allow for ventilation, whilst ensuring that the
cone is protected from rain ingress� The joint between the storm collar and the outer case of the flue should then be sealed with a
mastic sealant, which is purchased separately�
Storm Collar
This item is used in conjunction with the Metaloterm range of flashings and is purchased separately� The storm collar should be
positioned immediately above the cone of the flashing, leaving a gap large enough to allow for ventilation, whilst ensuring that the
cone is protected from rain ingress� The joint between the storm collar and the outer case of the flue should then be sealed with a
mastic sealant, which is purchased separately�
Terminals
Terminals are supplied complete with a locking band� Once the terminal has been pushed into place, the adjustment bolt on the locking band clip should be tightened to ensure
that the terminal is properly secured to the previous pipe�
Top stub
All weather cap
All weather cap with inspection
15
Metaloterm
®
MF
-
