ADJUSTMENT
See Figure L.
6 To adjust the motor pulley height, (so the
belt doesn’t walk itself off of the edge of
the platter), loosen the set screw at the
bottom of the pulley wheel using the 0.05”
allen key and push the pulley up or down.
See Figure M.
7 To adjust the cueing height, loosen the
set screw on the back of the cuing disc
using the 5/64in allen key. You can raise
and lower the cuing disc on the cuing
plunger as needed. Tighten the set screw
when finished. See Figure N.
8 To adjust the anti-skate weight, you
will need a grooveless record. Using one
of the three anti-skate weights and the
monofilament line provided, adjust until the
stylus is steady on the grooveless record.
See Figure O.
ANTI-SKATE
MOTOR PULLEY HEIGHT
CUEING HEIGHT
FIGURE O
FIGURE L
FIGURE M
FIGURE N
Summary of Contents for SOL
Page 15: ......
Page 16: ...SCHIIT COM INFO SCHIIT COM ...
