Location selection:
Take particular care when choosing a location.
Install the swing above a level surface and at least 200cm away from other structures or obstacles, e.g. fence, gara-
ge, house, sweeping branches, clotheslines or electrical ca-bles.
Do not install the swing over hard surfaces (e.g. concrete, asphalt). It is recommended to line the floor under the
swing with cushioning material (e.g. wood mulch, shavings, rub-ber mulch). Check the condition of the ground
regularly and loosen or fill it up again if necessary. Never install the product above water (e.g. paddling pool, river,
lake, etc.). Risk of drowning.
Please ensure that the swing frame is sufficiently stable. For swings with crossbars, no responsibility can be taken
for the stability. The manufacturer‘s specifications apply. If necessary, seek advice from a specialist. It is essential to
note the load capacity of the swing base structure.
Assembly:
Check the delivery for completeness. Check if individual parts are damaged. If so, do not use the product. This
swing is fully assembled and ready to use right out of the box.
Suspension and adjustability:
The swing can be hung on a suitable swing carrier with the help of the supplied retaining rings. The suspension
means (retaining ring) is always delivered pre-assembled. The suspension points must be at least the width of the
swing seat (+ 100mm) apart. The suspension connections must be designed in such a way that they cannot be
accidentally loosened.
The rope lengths can be adjusted using the two pre-assembled height adjustment links. Push the rope evenly
through the links. Moving it upwards shortens the rope, moving it downwards lengthens the rope. The ropes must
have the same length on each side. Uneven rope lengths lead to restless swing movements. Never hang on the
ropes crossed or on only one suspension point. Carry out a stress test and make light test swings before starting.
Storage and maintenance:
Store the product in a dry and dark place out of the reach of children.
Protect the product from direct sunlight and other heat sources. These affect the UV sta-bility and the material
ages faster. Continuous exposure to UV light can fade colors. This is not a safety hazard. To avoid early bleaching
and corrosion, and to extend lifetime, the product should be disassembled when not in use, especially in winter.
The swing must be checked and maintained for damage and wear before and after each use: Check that all nuts and
bolts are properly tightened. Tighten these if necessary. Oil all moving metal parts regularly. Check swing seats,
ropes and other accessories for signs of wear and tear and replace defective parts according to the manufacturer‘s
in-structions. Neglected control and maintenance can lead to serious injuries due to materi-al failure.
Only clean the product with a damp cloth. Do not use any cleaning agents, only water.
Disposal:
Send the packaging and the product to a return and collection system at the end of its service life. You can obtain
information on this from your local waste disposal company.
EN
5
