automatic hose rewinder ST 260/350 and EST 265
installation and operating instruction
installation and operating instruction ST 260_350-EST 265 - A5
page 2
01.04.2021
Schill GmbH & Co. KG; Bruckstraße 44; 70734 Fellbach
INTRODUCTION
All information necessary for a correct assembly to ensure trouble free operation of the cable reel are described in the pres ent operating
instructions. The warranty given by the manufacturer is only valid if these operating instructions are observed and adhered to. Terms and
conditions are available upon request or at
https://www.schill.de/en/footer/general-terms
Additional user manuals for other product variants can be found at
https://www.schill.de/en/downloads
"CONTACT").
GENERAL
The automatic hose rewinder provide a modern air supply at workstations. They are used to supply compressed air to mobile terminals. The
hose is only pulled out when needed and in the required length. The remainder stays neatly stored on the hose reel and is protected from
contamination and damage. The air connection is always accessible, but never in the way. The hose length can be easily adapted to a
changing work situation. There is no hose chaos, no tripping hazard anymore. If the hose connection is no longer needed, a short pull on the
hose stopper will suffice and the hose will roll up neatly. The automatic hose rewinder provides safety and order.
HANDLING
The coiled hose should be pulled out to the required length against the spring tension, but please refrain from the use of undue force. The hose
is coiled and fixed in position as described under "LOCKING DEVICE". The hose should never be pushed in manually. If the hose becomes
entangled when winding it onto the reel, simply pull the hose out again and then rewind.
MAINTENANCE
The cable reel does not require any maintenance, due to the excellent antifriction properties of the plastic bearing. However, the cable must
be checked in regular intervals for damages and replaced if necessary (see "EXCHANGING THE PULL-OUT HOSE
”).
CONTINOUS OPERATION
The cable reel is designed for manual use in workshops. The standard cable reel is fitted with a standard available cable. If used for
automated applications when a high degree of mobility is required, the standard applied cable has limitations. A special cable with a support
core should be used in those applications. In order to ensure a reliable function, the cable lengths must be reduced by at least 1/3. If you
consider automated applications, please contact the manufacturer up-
front (see “CONTACT”).
SPIRAL SPRING
The spiral spring is subject to natural wear and tear and can result in a fatigue fracture of the spring steel. Based on experience, we
recommend changing the spring after approx.
30.000 operations. The term “operations” defines not only a complete winding and unwinding
of the spring but also includes a partial movement of the spring. For a safe replacement of the coil spring, please refer to paragraph
(“REPLACING THE SPIRAL SPRING”).
HOSE STOPPER
The length of the available hose can be individually adjusted with the provided hose stopper. The
reliable clamping adapts to various hose diameters between 6 and 12mm (ST 260 / EST 265)
and also 6
– 16mm (ST 350). For a thicker hose, a larger version is available. The stopper also
serves as a safeguard against retraction of the hose in case of a not intended release. It should
therefore never be removed.
