automatic hose rewinder ST 260/350 and EST 265
installation and operating instruction
installation and operating instruction ST 260_350-EST 265 - A5
page 3
01.04.2021
Schill GmbH & Co. KG; Bruckstraße 44; 70734 Fellbach
LOCKING DEVICE
As a standard feature the hose reel has a disengageable hose locking device. The
latching mechanism ensures that the pulled-out hose stays without traction fixed in
place. When the hose is being pulled out, the spring detent passes over a series of
grooves. An audible click indicates that the locking device is engaged. If you gently
rewind the hose after the clicking sound, you will notice that the spring detent will
engage into the notches, locking the hose in position. The hose can be disengaged
by gently continuing to pull the hose until the click can no longer be heard. The
tensioned spring will pull the hose back onto the reel.
The locking device
ST 260/350
can be disengaged by pulling the knurled grip out by approx. 1cm and turning it between 90° and 180°.
This will disengage the locking device the cable is then constantly under tension.
ATTENTION
Do not release the hose when rewinding, the tension of the spring can accelerate the winding speed to such a degree that the
swinging hose end could cause injury. Also damage to the hose and spring could be the result of such an action.
CONNECTION
The hose reels are unless otherwise agreed supplied without connection
hose.The connection hose can be mounted in a individual length to the
existing screw
connection. The hose requires a hose screw with 6-KT
nut
and thread R1/4" inside. The nut can be tightened with a fork key,
but excessive use of force must be avoided.
Attention
Connect the connection hose only with a suitable connector, achange can escape compressed air.
EXTENSION HOSE
The included standard hoses are designed to tolerate the weight of the pulled-out hose including the hose stopper. Additional weights are
not allowed. The mounted hoses are limited to the specified lengths. Never use excessive force to unwind the hose as this can damage both
the hose and the reel. Should the cable be blocked while coiling up, please pull the cable out again and recoil. Attention should also be paid
to section „GENERAL" and “CONTINOUS OPERATION".
In the case of versions without pull-out hoses, the hose is connected as described under "" EXCHANGING THE PULL-OUT HOSE
”
MEDIUM
The hose reels are designed as compressed air drums for use with air guns, paint syringes, tire service etc. The standard assembly is done
with a resistant, fabric-reinforced rubber hose 6 mm NW. Swivel joint and hose are not suitable for use with other media, in these cases we
ask for request.
PRESSURE LOAD
Please observe the information on the product label. If the pull-out / connection hose is fitted by yourself, the guide values for hose loads
must be observed.
READY FOR USE
After connection to the compressed air supply (see "CONNECTION") the hose roller should be ready for use. Before commissioning, check
the tightness of the reel.
