automatic cable rewinder FT 038 e-mobility with integrated charging electronic
installation and operating instruction FT 038.XXXX.I1X
installation
and operation instruction FT 038 e-mobility miL FT 038_XXXX
_I1X - A4
Seite 12
09.11.2022
Schill GmbH & Co. KG; Bruckstraße 44; 70734 Fellbach
READY FOR USE
If necessary, the max. charging current must be set.
Charging current setting:
The maximum charging current that the charging station provides the vehicle is set with DIP
switches 1 - 5. This setting is made at the factory to the max. permissible value and sealed
with locking varnish.
Before commissioning, please conduct an electrical check according to VDE 0100 or to the
respective national standard. Check that the end of the pull-out cable is correctly fitted with
a charging socket. After connecting to the power supply (see "CONNECTING"), the cable
reel should be live and ready for use. The LED (status control) luminate permanent white.
If this is not the case, the protective devices must be checked (see "PROTECTIVE
DEVICE").
If the electronics of the automatic cable rewinder are defective, please contact the
manufacturer (see "CONTACT").
ATTENTION
Danger to life from electric current!
Safety for life is only guaranteed if the monitoring device functions properly.
OPERATION
Starting charging process
1. The rewinder must be ready for operation the charging process. (LED: permanent
white
, see “READY FOR USE”)
2. Pull out the extension cable to the desired length and lock.
3. The protection cap of the charging plug has to be removed.
4. The plug is to be inserted into the vehicle. The vehicle then recognizes the connected
charging station. (LED: permanent green)
5. The charging process is started by the vehicle. (LED: permanent BLUE)
Info:
For details about starting the charging process of the vehicle, please refer to the
instructions of the vehicle manufacturer.
Ending charging process
1. The charging process is ended by the vehicle. (LED: permanent GRÜN)
2. The charging plug has to be removed from the vehicle
3. the protection cap has to be pushed on the plug.
4. wind up the charging cable by pulling the cable briefly
I
nfo
: For details about ending the charging process of the vehicle, please refer to the
instructions of the vehicle manufacturer.
