Schiller Grounds Care 75-70666, Owner'S And Operator'S Manual

Skid shoe adjustment:

.LEVEL PAVED SURFACE: Adjust skid shoes to  allow 

3/16” to 1/4”  or 5mm to 7mm clearance (A)  between 

cutting edge and surface.   

UNEVEN OR GRAVEL SURFACE: Adjust skid shoes  

to allow 1/2” to 5/8” or 13mm to 16mm clearance (A)  

between cutting edge and surface.

STEP 3  

ADJUSTMENTS  

Drive pulley adjustment:

NOTE: Place the tractor horizontally on a flat surface.  

1. For model 235:  

 The tractor pulley (item 60)  and the snowblower  pul-

ley (item 61) must  be  well aligned (this is to  ensure 

a longer life span of the belt).  

 For model 430:  

 The tractor pulley and the snowblower pulley must  

slightly misaligned  (about 1/16’’ to 1/8’’ (item  B)).  

Make  sure there is no  contact between the two  

belts when they are in the highest position.  2. Do  

the same tests  as in snowblower installation  sec-

tion, item 9.   

If the snowblower starts and proper tension is used,  

the pulleys are misaligned too much.  

If at the highest position the two belts  come into  

contact with each other, There is not enough space  

between the pulleys.   

STEP 4  

SNOWBLOWER REMOVAL  

INSTRUCTIONS:  

1.  Lower the snowblower and stop engine   

TO PREVENT INJURIES: STOP THE MOTOR.  AP-

PLY PARKING BRAKE. REMOVE THE IGNITION  

KEY.  

DISCONNECT THE WIRE FROM THE SPARK PLUG 

(S) AND KEEP AWAY FROM SPARK PLUG(S) TO  

PREVENT ACCIDENTAL STARTING

.

2.  Disconnect the two hydraulic hoses and install  

dust covers.  

3.  Remove the drive belt and release the quick  

hitch. Start the engine and back out carefully.  

4.  Remove the four weights from the weight bar for  

the 4 wheel drive unit.  

5.  For model 430, move the stopper into the  

disengaged position.( See step 2).   

10   

ADJUSTMENTS & REMOVAL