OPERATION:
1. Do not put hands or feet near, under or inside
rotating parts.
2. Exercise extreme caution when operating on or
crossing gravel drives, walks or roads. Stay alert
for hidden hazards or traffic. Do not carry passen-
gers.
3. After striking a foreign object, stop the engine (mo-
tor), disconnect the wire from the spark plug(s)
and keep wire away to prevent accidental starting.
Thoroughly inspect the accessory for any damage
and repair damage before restarting and using the
accessory.
4. If the unit should start to vibrate abnormally, stop
the engine (motor) and check immediately for the
cause. Vibration is generally a warning of trouble.
5. Take all possible precautions when leaving the
vehicle unattended. Disengage the power take-off,
lower the attachment, place the transmission into
neutral, set the parking brake, stop the engine and
remove the contact key.
6. Never use the accessories across the face of
slopes, go from top to bottom. Exercise extreme
caution when using equipment on slopes. Do not
attempt to clear a steep slope.
7. Never tolerate bystanders in the working zone.
Never use an accessory in the direction of by-
standers, it might throw gravel or debris that can
hurt people or damage property.
8. Never operate the accessory at high transport
speeds on slippery surfaces. Use care when
backing up.
9. Do not carry passengers.
10. Disengage power to the accessory when it is
transported or not in use.
11. Never operate the accessory without good vis-
ibility or light.
MAINTENANCE AND STORAGE
1. When cleaning, repairing or inspecting the vehicle
and accessory, make certain that all moving parts have
stopped. Disconnect wire from the spark plug(s) and
keep wire away to prevent accidental starting.
2. Check all the bolts and components at frequent
intervals to make sure that they are properly tightened.
3. Always refer to the owner’s manual when you store
the accessory and vehicle for a prolonged or an un-
specified length of time.
4. Maintain or replace safety and instruction labels, as
necessary.
5 Let the engine run for a few minutes after cleaning
snow in order to prevent the rotary parts from freezing.
5
SAFETY
Summary of Contents for 75-70666
Page 2: ...2 ...
Page 19: ...PARTS SECTION PARTS SECTION 17 ...
Page 20: ...PARTS BREAKDOWN SB448 SNOWBLOWER 18 ...