7
Hydro
Midsize
GENERAL INSTRUCTIONS
r) Stop the engine:
•
whenever you leave the mower;
•
before refuelling.
s) Shut the engine (motor) off and wait until the blades
come to a complete stop before removing the grass
catcher or unclogging chute.
t) Reduce the throttle setting during engine shut down
and, the engine is provided with a shut-off valve,
turn the fuel off at the conclusion of mowing.
u) Go slow when using a trailing seat.
v) Keep washout ports and other mower-housing
service openings closed when mowing.
x) Do not engage PTO at full throttle. Throttle midway
between idle and highest possible engine speed.
y) Do not start the cutting blades until you are ready
to start mowing.
z) Do not carry passengers.
aa) Do not operate where flying debris may injure people
or damage property. Keep people and pets at a safe
distance.
ab) Do not use if there are any doubts about safety.
ac) Keep labels, guards and shields in place. Replace
operators manual if lost or damaged.
ad) Obey safety instructions. Failure to do so may cause
injury to yourself or others.
ae) Do not defeat interlocks. Check operation daily.
af) Do not allow children, unskilled or untrained persons
to operate machine.
OPERATING ON SLOPES
USE EXTRA CARE WHEN WORKING ON SLOPES
•
With walk behind machines, mow across slopes,
not
up and down. With ride-on machines, mow
up and down slopes,
not
across, except zero turn
machines. Zero turn machines should mow across
slopes.
•
Be alert to dips and rises which change the general
slope. Watch for holes, rocks and roots in the terrain
and other hidden hazards. Keep away from drop
offs. Avoid ground conditions which will cause the
machine to slide.
•
If the operator is uncomfortable or unsure of the
machines stability, operation on these slopes should
cease immediately.
•
The ultimate responsibility for safe operation on
slopes, rests with the operator.
•
Use lower speeds and exercise extreme caution
on slopes and especially in sharp turns to prevent
tipping and loss of control. Use extra caution when
changing direction on slopes.
LEAVING THE DRIVING POSITION
Park the machine on level ground. Before leaving the
driving position, stop the engine, make sure all moving
parts are stationary and that the traction control levers
are in the neutral position. Apply parking brake.
MAINTENANCE AND ADJUSTMENTS
•
Disconnect spark plug wire(s) before doing any
maintenance.
•
Particular care must be taken when adjusting the
carburetor while the engine is running. Keep hands
and feet clear. Shut off PTO.
•
When working underneath lifted parts or machines,
make sure adequate support is provided.
•
Do not dismantle the machine without releasing or
restraining forces which can cause parts to move
suddenly.
•
Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
•
Check the grass catcher frequently for wear and
deterioration.
•
Replace worn or damaged parts for safety.
STORAGE
•
Never store the equipment with gasoline in the tank
inside a building where fumes may reach an open
flame or spark.
•
Allow the engine to cool before storing in any
enclosure.
•
To reduce the fire hazard, keep the engine, muffler,
battery compartment and gasoline storage area free
of grass, leaves or excessive grease.
•
If the fuel tank has to be drained, this should be
done outdoors.
•
Use only replacement parts supplied by the original
manufacturer.
