Schiller BOB-CAT 942512G, Operator'S Manual

4

PREDATOR-PRO 

SERIES

OPERATING SAFELY

In general

– 

Use extra care when loading or unloading the 
machine onto a trailer or truck.

–  Watch out for traffic when near or crossing 

roadways.

– 

Do not run the engine in an enclosed area where 
dangerous carbon monoxide fumes can collect.

– 

Do not place your foot on the ground while 
operating the machine. 

– 

Before operating, lower the discharge chute, 
install the mulcher or put the entire grass catcher 
in place.  

– 

Keep clear of the discharge opening at all times. 
Never direct the discharge toward a bystander.  
Stop operation if someone approaches.

– 

Keep washout ports and other mower housing 
service openings closed when mowing.

– 

Use care when pulling loads or using heavy 
equipment.

-  Use only approved drawbar hitch points.

-  Limit loads to those you can safely control.

-  Do not turn sharply.  Use care when reversing. 

-  Use counterweight(s) or wheel weights when 

suggested in the operator's manual.

– 

Never leave a machine unattended.  Always turn 
off blades, set parking brake, stop engine and 
remove keys before dismounting.

Starting

– 

Start only according to instructions in this manual 
or on the machine.

– 

Before attempting to start the engine, make sure:

-  the parking brake is on; 

-  the PTO is disengaged;

-  the traction drive is in NEUTRAL.

– 

When starting the engine, make sure hands and 
feet are clear of the blades.

– 

Do not start the machine while standing in front 
of the discharge chute or with the chute directed 
at someone. 

– 

Do not engage PTO at full throttle.  Throttle to 
idle or lowest possible engine speed. 

– 

Do not change engine governor settings or 
overspeed the engine.  Operating the engine 
at excessive speed can increase the hazard of 
personal injury. 

MACHINE OPERATION

– 

Check operator present interlock system and 
brake operation.  Adjust or repair any problems 
before using. 

– 

Do not tamper with or defeat safety devices. 
Keep guards, shields and interlock safety devices 
in place and in proper working condition.  They 
are for your protection.

– 

Keep all fasteners such as nuts, bolts and pins 
well secured. 

– 

Visually inspect blades, blade bolts and the cutter 
assembly for wear or damage.  Replace worn or 
damaged blades and bolts to preserve balance. 

– 

Verify that machine and attachments, if any, are 
in good operating condition. 

– 

Do not engage blades until ready to mow.

SAFETY