Commissioning
©
by Antriebs- & Regeltechnik Schimpf GmbH
13
Commissioning
Important:
The “Safety instructions for installation and maintenance” and the
“Safety instructions for commissioning” provided in this
document must be observed during the commissioning phase.
Installation
The drive must be firmly screwed to the fitting to be moved using the available threaded
holes on the flange plate. The drive shaft has a square socket as standard. The
arrangement and size of the threaded holes as well as the square socket can be found
in the
and
document.
Adapters for other shaft designs are also available. An overview of the standard
adapters can also be found in the
at the end of this document.
Installing a Schimpf control valve
To mount a Schimpf drive on a Schimpf
control valve, insert the square spindle at
end of the valve shaft into the square
socket of the drive. Make sure that the
square socket of the drive and the square
spindle of the valve are the same size.
The valve is fixed in place using the two
hexagon socket screws supplied with the
valve. When installing, make sure that the
drive is in the correct position relative to
the valve (open or closed).
Specialised shafts and adapter sets for other valves are available on request.
