Operation
©
by Antriebs- & Regeltechnik Schimpf GmbH
50
be changed. If both end positions have to be
adjusted, parameter 0 must be selected.
Setting the end position that is opposite the other
end position in the counterclockwise direction
(CCW).
Use the
and
buttons to move to the “CCW”
end position. The
LED will flash. In the example,
the end position to be set is shown as a red arrow
and the second end position as a blue arrow.
Ensure that the end position does not lie outside the
permissible range of motion of the drive. The
“Enable” LED must be continuously lit. If the current
position is outside the valid range, the “Enable” LED
will flash twice. There are four markings on the
potentiometer; these are shown as red circles in the
adjacent illustration. The permissible range of
motion of the potentiometer is shaded in red. The
marking indicated with an arrow must always be
within the shaded area.
Press and hold the “Prog” button to set the CCW
end position. The “Prog” LED will flash briefly.