2
INSTALLATION
1
Set horn strobe options.
The following horn strobe options can be set in the field:
Brightness
: Strobe brightness measured in candella. Strobe brightness is set using the slider switch on the back of the horn
strobe (Figure 1).
Volume
: High or low
Tone:
Electromechanical tone
Code:
Non-temporal code (continuous tone) or temporal code (interrupted tone). Non-temporal code uses the pattern shown below.
ON
1/2 sec.
ON
1/2 sec.
ON
1/2 sec.
OFF
1/2 sec.
OFF
1/2 sec.
OFF
1-1/2 sec.
Repeat
pattern
The horn strobe is shipped factory set for high volume temporal (interrupted) code.
If necessary, change the setting before installing the horn strobe assembly.
Change the setting by turning switch on the back of the horn strobe (Figure 1). Switch settings are shown in raised lettering on the back
of the horn strobe.
CAUTION
Remove power from horn strobe before changing settings.
Audio Select Switch Settings
1 = Interrupted high
2 = Interrupted med
3 = Interrupted low
4 = Continuous high
5 = Continuous med
6 = Continuous low
Strobe Brightness Setting
Slider switch is used to set
strobe brightness. The setting
(in candella) can be observed
through front of strobe.
Figure 1, Location of Setting Switches (back of horn strobe)
