Install the light module.
• The light module can be used to control a lamp.
• The light module repeats the Z-Wave™ signal. In some homes, the
light module must be used to improve communication between the
bridge and the lock. See the "Understanding Signals" section for
more information. During the online portion of the setup, the system
will determine if it is communicating properly or not. You can move
the light module during online setup if necessary.
• The light module should be installed into any indoor, three-prong,
120 volt A/C outlet.
3
(Optional) Plug a lamp into the Z-Wave™ (two-prong) side of
the light module.
• There are two outlets on the light module. One of the outlets has
only two prongs and is labelled with a Z-Wave™ sticker. A lamp (25
watts minimum and 300 watts maximum) can be controlled by the
system if it is plugged into the Z-Wave™ side of the light module.
• Use only an incandescent light bulb in the lamp that is plugged into
the light module. DO NOT use a CFL (compact fluorescent light
bulb) or any other kind of electric device.
• The other outlet has three prongs and can be used simply as a
pass-through outlet (1500 watts maximum). It is not controlled by
the system, and the system is not affected when it is used.
4
Max. 300W
Incandescent
Z-Wave™
Side
Pass-through
Side
Install the 9 volt battery into the bridge.
• Use the 9 volt battery that is included in the box.
• Use any premium quality 9 volt battery for replacement.
5
