8
-
+
Enroll the lock into the bridge.
• Before you begin this step, find the six-digit lock programming code,
located in the "Important Information" box on the first page. For your
convenience, there is space to write the programming code below.
•
After you begin the enrollment process, you have 30 seconds
to complete the remainder of the steps. The bridge must
remain within 6 feet (1.8 meters) of the lock throughout the
enrollment process.
Press
Press
Press
Observe
__ __ __ __ __ __
then
Blinking*
On Bridge
(Six-digit lock programming code)
On Lock
On Lock
Observe
Blinking
Wait For
3 3 Beeps
Observe
Blinking
Success!
This portion of the setup is complete. For the next portion, you will need a computer that is connected to
the Internet.
• Internet Explorer 7.0 or Firefox 3.0 is required for proper operation. You can check your browser version by clicking
Help > About in the browser's menu. If you do not have the proper version, you can download a newer version from the
following web sites:
• Internet Explorer 7.0 (www.microsoft.com/windows/downloads/ie/getitnow.mspx)
• Firefox 3.0 (www.mozilla.com)
9
Using either Internet Explorer 7.0 or Firefox 3.0, browse to www.schlagelink.com.
Look for "Just purchased a Schlage LiNK System? Click here," and click the link.
Repeat this process for additional locks.
*NOTE: ONLY if you observe a red blinking light instead
of a green blinking light, exclude the lock from the
bridge and then try enrollment again.
a. Press and release the minus (-) button on the
bridge.
b. Enter the six-digit programming code on the
keypad and wait for three orange lights and
three beeps.
c. Press the Schlage button and then the zero (0)
button on the keypad and wait for three orange
lights and three beeps.
d. Wait for all lights to stop blinking. You should
then be able to enroll the lock normally.
