8
AD-200 Offline Lock User Guide
Function
Press/Present
Wait For
Confirmation
1
Add PIN
Credential
[Programming Code]
OR
Programming Card
Wait for
to stop flashing
between each
step.
New [PIN]
(for PIN only)
OR
New Card
add another credential
OR
to finish
Add Pass Through
Credential
[Programming Code]
OR
Programming Card
Wait for
to stop flashing
between each
step.
New [PIN]
(for PIN only)
OR
New Card
add another credential
OR
to finish
Add Pass Through
+PIN Credential
[Programming Code]
OR
Programming Card
Wait for
to stop flashing
between each
step.
New [PIN]
(for PIN only)
OR
New Card
add another credential
OR
to finish
Delete Credential
[Programming Code]
OR
Programming Card
Wait for
to stop flashing
between each
step.
Credential [PIN]
delete another credential OR
to finish
Change Relock Time
[Programming Code]
OR
Programming Card
Wait for
to stop flashing
between each
step.
to add 1 second AND/OR
to add 5 seconds
to finish
1 Other lights may show before the final confirmation. Wait for the final confirmation before continuing to the next
step.
USING THE LOCK
After credentials have been programmed, present credentials to operate the lock as follows:
Credential Type
Action
Credential
Present credential to reader
Î
Green blink and access granted
+ PIN Credential
Present credential
to reader
Î
Press PIN
Î
Within 5 seconds,
Press
#
1
Î
Green blink and
access granted
1 The “#” key is used as ENTER key for PINs with fewer than the minimum number of digits. Default minimum digits
is 6. This can be configured with the HHD, so users do not have to push the
#
key.
