6 • Schlage • AD-200 user guide
Cancel construction access mode
Do one of the following:
• Program the lock with the SUS. See the SUS user guide for more information.
• Reset the lock to factory settings. See
Reset to factory defaults
on page 15 for more
information.
When construction mode is cancelled, the master construction credential and all other
credentials added using the master construction credential will no longer function.
Credential types and functions
Programming credential:
A card or 5 digit code used only for lock programming.
Card or PIN credentials:
A card that is presented, or a 3-6 digit code entered on the keypad.
Card ID number:
When adding any new card credential, a 3-6 digit code is entered prior to
presenting the card. This code becomes the Card ID Number. This number can be used to
delete a card credential without physically having the card.
Keep a log of all Card ID Numbers
for future reference.
Note: A unique credential must be used for each credential type described below (for
example, a single credential may not be used for both normal use and toggle functions).
Credential type
Function
Programming PIN or card Used only to program the lock. Does not unlock the lock.
Normal use credential
Unlocks the lock
momentarily
after a credential is presented or
entered.
Toggle credential
Changes the state of the lock from locked (secured) to
unlocked (unsecured), or vice versa, unless in a Freeze state.
Freeze credential
Freezes the lock in the current state. The lock remains frozen
until any Freeze credential is presented again. (A pass-through
credential will override a lock in frozen state as described
below).
Pass-through credential
Unlocks a lock
momentarily
, regardless of state.
A valid Pass-through credential can unlock a door set to any
secured lockout mode (e.g., Freeze, Privacy, Time Zones,
Door Auto-Locks and Holidays). The door will relock after the
specified relock time.
Credential forms
Normal, toggle, freeze and pass-through credential types are used in one of three forms:
PIN
credential – a 3-6 digit code entered on the keypad.
CARD
credential – a card presented to the lock.
CARD + Card ID Number
credential – a card (with a unique Card ID number) presented to
the lock. (See a description of Card ID number above for more information.)
Steps for designating each form are in the
Manual programming instructions
on the following
pages.
