4.2
CONFIGURING THE READER PROPERTIES IN SYSTEM GALAXY
Reader behaviors can be configured from System Galaxy. This section briefly covers the options that can be set
from System Galaxy. See the System Galaxy Software manual for in depth instructions on reader properties.
4.2.1
SETTING READER PROPERTIES IN SYSTEM GALAXY
To configure a Reader Port, open the Reader Port window. Follow the menu
selections Configure >
Hardware > Reader Ports
, or click the
Doors/Readers button
on the toolbar.
Open the Reader Properties screen:
click on the Door button on the toolbar
,
{
Or from the menu, select
Configure > Hardware > Reader Ports
}
Select the loop
and
panel
that controls your DSI 485-Channel.
Select the specific Reader Name
you are setting up then c
lick the Edit button.
You can change the Reader Name
(up to 65 characters) to something that describes the reader (i.e. Room
101; supply closet). The system mapping for that board is still displayed above the reader name field.
The
Reader Type
field
will be disabled,
but it will display the format you assigned to this reader in the
Serial Channel properties screen
(PIM Wiegand or PIM ABA).
On the General Options tab, the PIM number is automatically set to the same value as the READER ID.
Figure 14 – Reader Properties: Configuring the PIM Number AD300 ONLY (HARDWIRED)
In this screen shot, notice that DSI Board-5 Section-2 Reader-4 automatically takes the PIM ID of 4.
Auto-numbering of the PIM ID is only done on dedicated AD300 networks.
System Galaxy Integration to Schlage AD400/AD300
Page 34
