Ordering Procedure
Schlage • AL-Series service manual • 39
Ordering Procedure
To order Schlage products, descriptive data should be in the same sequence as shown below.
Line
Item
Qty
Product
Outside
Inside
Hand
Latch Strike Dr
Thk
Ext
Dim
Additional
Details
DES
FIN
DES
FIN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Line Item: Line item number
Qty: Quantity
Product: Complete lock product or part number
Outside DES: Outside design code
Outside FIN: Outside finish code
Inside DES: Inside design code
Inside FIN: Inside finish code
Hand: Hand of door: Only one hand allowed per line item. Example: RH=right hand, LH=left hand, RR=right reverse, LH=left reverse
Latch: Leave blank for standard latch or specify part number if non-standard latch is required
Strike: Leave blank for standard strike or specify part number if non-standard latch is required. LLL=less strike
Dr Thk: Door thickness: Enter door thickness if non-standard, example 138=1
C\,
”, 214=2
Z\v
”, 212=2
Z\x
” (EI or EO assumes the latch will be
centered on 1” door, to which material has been added)
Ext: Extension: Enter one of the following when door 2” thick or greater are specified: EE=extended equally, EI=extended inside,
EO=extended outside, ED=extended differently
Dim: Dimension: Enter dimension for non-standard strike lip length and mortise cylinder or blocking ring length
Additional Details: Enter detail for keying information and for special requirements.
Limited Warranty
Schlage Lock Company (the “Company”) extends a three-year limited warranty from the original date of purchase to the
Original User of the products manufactured by the Company (the “Product”) against defects in material and workmanship.
Certain Products contain restrictions to this limited warranty, additional warranties or different warranty periods. Please see
below for specific Product warranty information.
The provisions of this warranty do not apply to Products: (i) used for purposes for which they are not designed or intended; (ii)
which have been subjected to alteration, abuse, misuse, negligence or accident; (iii) which have been improperly stored,
installed, maintained or operated; (iv) which have been used in violation of written instructions provided by Schlage; (v) which
have been subjected to improper temperature, humidity or other environmental conditions (i.e., corrosion); or (vi) which, based
on Schlage’s examination, do not disclose to Schlage’s satisfaction non-conformance to the warranty. Additionally, Schlage will
not warrant ANSI A156.2 Grade 2 lever Product installed in educational facilities and student housing.
Specific Product Warranty Restrictions / Additional Warranties
Small Format Interchangeable Core (SFIC) Warranty: This limited warranty also applies to Schlage locks and housings when
used with another manufacturer’s cores, or to Schlage cores (i.e. SFIC) when used in another manufacturer’s locks and
housings. The use of unauthorized cylinder cams or other components with the Products shall void this warranty.
Everest® Primus® Limited Lifetime Key Breakage Warranty: A limited lifetime warranty is provided to the Original User against
key breakage, subject to the restrictions of this limited warranty.
