3
English
LoCk SetuP
Follow these steps to get your lock set up and ready to use.
If you would like to use a home automation system, refer to
Z-wave Functions
on page 10.
1
Decide what length you want the user Codes for the lock to be.
You can set User Codes to be from 4 - 8 digits in length. The default length is 4 digits. All User Codes must be the same length.
Any time you change the User Code length, all current User Codes will be deleted from the lock.
•
See
Change User Code Length
on page 6.
2
Add/Delete user Codes.
The lock comes preset with two unique User Codes. You can either use these codes or remove them and program your own
codes.
•
See
Add User Code
and
Delete User Code
on page 6.
3
Decide if you want to use the Auto-Lock feature or not.
When the Auto-Lock feature is enabled, the lock will automatically relock itself 30 seconds after being unlocked.
•
See
Enable/Disable Auto-Lock
on page 7.
LoCk PARtS
DOOR
INTERIOR
Assembly
DOOR
EXTERIOR
Touchscreen
Schlage Button
Touchscreen
Cylinder
Thumbturn
Bolt
Thumbturn
•
Used to lock and unlock manually from the inside.
Schlage
Button
•
Located on the outside of the door.
•
Press to exit programming mode immediately.
•
The first button you will press when entering a user and in the
programming process.
Touchscreen
•
Located on the outside of the door.
•
Used to enter codes for programming and unlocking.
•
Remains unlit until the Schlage button is pressed.
Cylinder
•
Used to unlock only in emergency situations.
See Emergency Key
Override on page 9.
Bolt
•
Automatically extends and retracts when the touchscreen is used.
•
Manually extends and retracts when the thumbturn is rotated.
Summary of Contents for BE468 series
