KC9111/KC9111-2 & KC9321/KC9321-2 INSTALLATION
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
57040-E Page 7 04-2007
3) Make Room for Key Cylinder:
4) Hold Dead Latch in Place:
5) Verify Placement of Dead Latch:
Due to the diameter of the key cylinder, it is necessary
to have dead latch (a) placed out of the way when
installing the key cylinder. Therefore...
•
Using your finger or a pair of needle-nose
pliers, push dead latch towards the top end
of trim as indicated by arrow in photo.
NOTE: As indicated by arrow in photo, you’ll notice
that when you push the dead latch forward, it will
swing a little bit in a counterclockwise direction.
a
To insure that dead latch is placed far enough out
of the way to allow key cylinder to be threaded in
properly:
•
Insert a finger into key cylinder hole and
hold dead latch firmly in place.
•
Carefully turn the trim over while keep-
ing the dead latch in position.
Two holes on dead latch (
a
) should be showing within
the two holes (
b
) in baseplate.
Fig. 1
b
a
b
