1
Mount power supply
1a Mark 2 Top Holes
1b Secure Enclosure with 4 Screws
Mounting notes
The PS902 must be installed in accordance with the article 760 of the National Electrical Code or NFPA 72, Canadian Electrical Code, or
any other applicable codes.
Install the PS902 indoors within the protected premises.
Check national and local codes for additional installation requirements.
Enclosure must be firmly mounted to a solid surface using hardware suitable for the surface.
x
x
2
Secure enclosure door
If No Keylock
Enclosure will be secured with 2
screws as shown (done as last step)
If Keylock
Remove knockout and insert key cylinder, then slide in clip
a
b
OR
Board not shown for
clarity
