8
ENGLISH
7e Test bolt alignment.
1. Close the door.
2. Insert a flathead screwdriver into the slot in the bolt, as shown.
3. Rotate the screwdriver toward the door edge to extend the bolt into the hole in the
frame. This operation should be smooth. You should be able to rotate the screwdriver
90˚, fully extending the bolt.
4. If the operation was not smooth, or if the bolt did not fully extend, adjust your frame
and/or door preparation. Go to
answers.schlage.com
and watch the video
Proper
Alignment of Door and Frame for a Smoothly Operating Lock
for further instructions.
5. Retract (unlock) the bolt before continuing to step 8.
»
If the deadbolt continues to rub against the strike, contact Customer Support for an
alternate strike with an additional .060” (2 mm) clearance.
Retract the bolt
before continuing
to step 8.
CAUTION
Test from the inside to
avoid being locked out!
If you can rotate the
screwdriver a full 90˚,
then the bolt is fully
extended.
8
Install the Touchscreen Assembly.
8a Install the Touchscreen on the outside of the door.
Always remove the spacer for a 1
Z\x
” (38 mm) crossbore. See
Spacer Removal
on page
14
before continuing.
»
The clips snap into the
crossbore
(see step 5 on page 5)
to assist in holding the
keypad on the door.
»
The Touchscreen Assembly should install smoothly. If it does not, check that the bolt is
set to the correct
backset
(see step 7a on page 6)
.
»
NOTE: If you have a
crossbore
(see step 5 on page 5)
that is slightly less than 2
Z\,
”
(54 mm), the lock may not install smoothly. You can remove the spacer.
Clips snap into
the
crossbore
.
Align the tab
with the notch.
Route the cable
under the bolt.
Summary of Contents for SENSE
Page 16: ......
Page 17: ...Guía de instalación CERRADURA INTELIGENTE ...
Page 32: ......
