SE
MOUNTING
TRACK
PLUG
(TOP)
ARM
ADJUST.
SCREW
COVER
PLATE
SPACER
COVER
SCREW
MOVABLE
COVER
INSERTS
(R.H. or L.H.)
CLOSER
COVER
1. With power on, open door completely. Door should remain in
open position. If door does not stay open, check electrical input.
2. Push release test switch. Door should close immediately. Open
the door to hold-open position and let it remain there.
3. System should be checked at frequent intervals. It is suggested
that step 2 be repeated every 90 days.
ELECTRICAL CHECKOUT:
HOLD OPEN FORCE ADJUSTMENT:
Locate
hold-open adjustment screw in diagram to the
right. For greater hold open force, insert
socket screw key wrench (included in screwpack)
and turn clockwise. To decrease amount
of hold open force, turn screw counter-clockwise.
Maximum of 4 turns.
WIRING DIAGRAM - POLARITY NOT IMPORTANT
INPUT VOLTAGE:
24V AC/DC OR 120V AC/DC
(usually from alarm panel or detector)
FOR 12V AC/DC wiring
consult factory
HOLD-OPEN FORCE
ADJUSTMENT SCREW
SOLENOID
ASSEMBLY
TERMINAL
LEADS GROUND
TERMINAL
CONDUIT
HOLE PLUG
RELEASE
TEST SWITCH
TO EITHER TERMINAL
OPTIONAL SWITCH
TO EITHER TERMINAL
SE TRACK
ASSEMBLY
END
PLUG
HAZARDOUS VOLTAGE
CAN SHOCK AND
CAUSE SEVERE INJURY
Disconnect power before
making any electrical
connections or performing
maintenance.
WARNING
!
