How to connect a NO/NC contact on Classic PDU and ethernet PDU?
The sensor port makes use of the RJ12 6P6C standard (= 6 position, 6 conductor). To connect a NO/NC contact on the PDU
sensor port, you have to make use of pin 1 and pin 6 ; as shown in the image below.
How to connect NO/NC contact on a G3 PDU?
3rd generation PDUs and DPMs are equipped with a USB-port and are able to operate two NO/NC dry switch contacts:
Note that on a PDU
only 1 NO/NC contact
can be connected.
Status of the contact will be displayed. The state cannot be changed locally.
Classic PDUs (= without ethernet port) do not support a NO/NC contact
Page 12 of 58
V262_User manual
Schleifenbauer PDU