How to configure IPv6?
3
https://en.wikipedia.org/wiki/Link-local_address#IPv6
The IPv6 settings can be found in the PDUs web
interface at the tab < Interfaces> block < Network
Configuration >.
The PDU will always generate a Link-local address
which starts with "FE80::".
This address is auto-generated and loses its scope at
the first encountered network node.
3
The IPv6 addresses can be found on the web
interface or on the "IPv6 Link" page on the PDU
display as shown in the image below.
To enable IPv6 support, the user must login to the
PDU using the IPv4 address presented on the
display. After login, select the tab "interfaces". In
section network configuration is a drop-down box
called "IP Protocol select". The default value of this
drop-down box is "IPv4 only".
To enable IPv6 set this to either "IPv6 only" or
"IPv4/IPv6 dual-stack", which means the PDU can
communicate through both protocols.
Note that selecting "IPv4 only" or "IPv6 only"
requires one of the filtering ranges to be all zero
(allow all addresses). This is to prevent users from
locking themselves out. Filtering ranges can be
configured afterwards when the user has connected
to the bridged and/or hybrid PDU using the protocol
previously specified.
Enabling IPv6 adds an additional page to the PDU
display named "IPv6 LINK" (see image). The current
IP Mode is also visible if the user navigates to the "IP
INTERFACES" display.
Page 45 of 58
V262_User manual
Schleifenbauer PDU