Procedure (continued):
5. Unlock “Certificates” block
6. Set “Use custom certificates” to enabled
7. Load your certificate into an editor, select the text and paste it in the appropriate box
8. Load your private key into an editor, select the text and paste it in the appropriate box
9. Click “Save Changes”
10. Go to the system tab and reboot the PDU to actualize your new configuration.
How to send SNMP Traps with IPv6?
The PDU allows the user to set two SNMP trap destinations. Traps occur when an alert has been triggered in the PDU.
These destinations are located at "interfaces → SNMP" in the PDU web interface. The "trap destination address" fields can
be set to IPv4 addresses if IPv4 is enabled and IPv6 addresses if IPv6 is enabled, or both when dual-stack is enabled at IP
Protocol select.
Using IPv6 traps
Page 49 of 58
V262_User manual
Schleifenbauer PDU