©
Schletter GmbH
as of 10/2016
PvMax3
Mounting Instructions
4
/
35
1. General Information
1.1. Short Description
PvMax3 is a modular unit assembly system for the installation of ground-mount substructures in high-quality and efficient
aluminum design. As the individual components have been optimized and structurally synchronized, a minimum system
price is achieved. PvMax3 allows to use framed as well as unframed modules that can be mounted either in portrait or in
landscape, or with the Schletter combined clamping system. It is also possible to mount additional accessories for the cable
management or components for the internal potential equalization.
1.2. Intended Use
PvMax3 is a substructure for the mounting of photovoltaic modules. Any kind of different use that is not mentioned in
these Mounting Instructions or an incorrect mounting (e.g. the utilization of components made by other producers or non-
observance of tolerances specified here and/or exceeding the indicated loads) are considered as non-intended use and, thus,
exclude any liability of the manufacturer.
The manufacturer accepts no liability for damage caused by failure to observe these Mounting Instructions.
1.3. Copyright and Intellectual Property Rights
The entire content of these Mounting Instructions is the intellectual property of Schletter GmbH and is subject to the
German copyright law.
Any reproduction, editing, propagation, transfer to third parties - also in excerpts - and any kind of utilization beyond the
limits of the copyright law must be approved in writing by Schletter GmbH.
Schletter GmbH reserves the right to take legal action in case of infringements.
These Mounting Instructions are subject to change without notice.
All names of products stated in these Mounting Instructions are trademarks of Schletter GmbH and are herewith recognized
and acknowledged.
Schletter GmbH is not liable for any damage of a product or consequential damage caused by the product that are due to
improper handling.
First and foremost, Schletter GmbH is not responsible or liable for failures and faults that are caused by modifications made
by the customer or other persons.
There is no claim for availability of previous designs and for the ability to retrofit delivered components to the respective
latest state of the series.
Schletter GmbH has made considerable efforts to make sure that these Mounting Instructions are free of
errors and omissions.
Schletter GmbH takes no responsibility respectively liability for faults that may be part of these Mounting
Instructions for example for direct or consequential damage that arise from placing these Mounting
Instructions at your disposal.
