Schleuniger CCM 1200
33
+
To restart the same programme you must first press [quantity] and [enter]. In our example
we have described how you can insert the cable into the CCM 1200 . There are two other
alternatives for this process which will save you time particularly in everyday use:
•
Insert the cable between the cable guides until it touches the feed rolls. Press [feed].
The cable is moved until you release [feed]. You obviously cannot insert a 10 mm thick
cable if the feed rolls have been set to 3 mm, otherwise the unit will block. In this case
turn the T-grip in the „UP“ direction until the cable feed is functioning again.
•
If you press the roller lever downwards the upper feed roll will be raised and you can
remove or insert a cable. This is helpful for example if you wish to process a number of
cable rolls using the same material.
Selecting the batch size
With the CCM 1200 you can select batch sizes of between 1 and 999'999 nos. The CCM 1200
stops each time a batch has been completed. To start the next batch press [run].
Programme step
Key sequence
Display
Activate „Batch mode “.
Hold [1] down whilst
switching on the
master switch.
quantity
length
speed
Select the length of the cable to be cut,
for example 450 mm.
[length]
[4 5 0]
[enter]
quantity
length
speed
Switch off the Hotprint mode if it has
been switched on. (If Hotprint mode
has been selected a 1 appears in the
right hand side of the display).
[clear]
[enter]
quantity
length
speed
Select the total quantity of 12 cables.
[quantity]
[1 2]
[enter]
quantity
length
speed
Select the batch size of 3 no.
[3]
[enter]
quantity
length
speed
Start the processing.
[run]
quantity
length
speed
Each time a batch is completed start
the new batch until the programme is
complete.
[run]
[run]
[run]
quantity
length
speed
HOTPRINT-MODE
12 450
PRINT 0 / 1 0
END OF BATCH
0 450
END OF PROGRAMM
BATCH ? 0
