38
Schleuniger CCM 1200
Replacing the V-belt, blade drive
Switch the master switch off. Remove the mains plug from the power supply. The
following work must only be carried out by specially trained personnel (Schleuniger
representatives, the user’s trained specialist personnel).
•
Remove the cover together with the
ejector shaft (Figure 12, Page 37).
The V-belt for the blade drive is
shown in Figure 13.
•
Remove the square-shaped cover
on the rear of the automatic unit.
•
Undo both screws on the blade
drive motor (Figure 14). The motor
will slide downwards; if it doesn’t,
slide the motor down slightly using
your hand.
•
Remove the defective belt from the
V-belt disc and fit the new belt.
•
To set the belt tension simply slide
the motor upwards until the required
tension has been achieved, then
tighten the screws.
•
Fit the two covers.
•
Insert the mains plug into the power
supply.
Figure 13. Blade drive feed belt
Figure 14. Screws on blade drive motor
V-belt
Pouley
blade drive
blade drive
Screws blade
drive motor
