Schleuniger CCM 1200
41
Aligning the blades
Switch the master switch off. Remove the mains plug from the power supply. The
following work must only be carried out by specially trained personnel (Schleuniger
representatives, the user’s trained specialist personnel).
•
Remove the cover together with the
ejector shaft (Figure 12, Page 37).
•
Clean the inside using a paintbrush
and vacuum cleaner attachment.
•
Loosen three nuts on the bottom
blade - do not remove (Figure 17,
Page 40).
•
Slide the wedge together with the pin
fully to the left.
•
Remove the upper screw on the
connector rod. This is secured with a
lock nut
(Figure 15, Page 39).
Warning: The upper blade will
now fall down!!
Figure 18. Aligning the blades
•
Press the lower blade against the holder using a finger and slide the wedge as far as possible
to the right (Figure 18).
The bottom blade must be kept in
the vertical position when carrying
out this alignment and should not
be allowed to tilt on any account.
Otherwise the lower blade will be
pressed against the upper blade
like a lever when the screws are
tightened. This can damage the
entire blade suspension. The
bottom blade must therefore be
pressed firmly in the holder.
Figure 19. Fitting position of lower
blade
Bottom
Upper
Socked head screw
blade
blade
middle upper blade
Press bottom
blade in here
