42
Schleuniger CCM 1200
•
Tighten the nuts.
•
Move the upper blade up and down. The blades should just touch but not jam.
•
Now carry out a manual cut on thin strips of paper across the whole width of the blade. The cut
should always be even and sharp. If necessary, repeat the alignment procedure until the
required cutting quality is achieved.
•
Fit back the cover.
•
Insert the mains plug into the power supply.
+
The blades may produce a poor cut in the middle. You can solve this problem using the
socket head screw in the middle of the upper blade (Figure 18, Page 41):
•
If the paper is only jammed in the middle of the blade and not cut then tighten the
socket head screw slightly.
•
If the blade jams in the middle then loosen the socket head screw.
