Schleuniger CCM 1200
43
Special Settings
Unit of measure, changing the standard setting
Switch the master switch off. Remove the mains plug from the power supply. The
following work must only be carried out by specially trained personnel (Schleuniger
representatives, the user’s trained specialist personnel).
•
Remove the control panel (4
or 6 screws).
•
On the rear of the control
panel you will find two Dip
switches next to the
connector terminal J7. One is
marked „mm“ and one „inch“
(Figure 20). Switch these
switches to the desired unit of
measure.
•
Fit back the control panel.
•
Insert the mains plug into the
power supply.
Figure 20. Setting the unit of measure
Making the Hotprint mode the standard setting
Switch the master switch off. Remove the mains plug from the power supply. The
following work must only be carried out by specially trained personnel (Schleuniger
representatives, the user’s trained specialist personnel).
In order to make the Hotprint mode the standard setting proceed exactly as described above in
the section entitled „Unit of measure, changing the standard setting “. See Figure 20 for the
correct Dip switch.
connector
J10
Dip-switch
mm and inch
Connector J7
Dip-switch
Hotprint-Mode
