11. Maintenance / maintenance schedule
Reference Manual |Edition 4.0 (10-2013) |EcoCut 3300
69|108
11.9.5
Replacing belts
1» Open the cover of the machine, see chapter
"11.9.2 Opening the housing (Page 65)"
.
2» Turn the machine to the side of the wire
entry. Place on a soft pad.
3» Remove both screws of the transport motor
(1) and then both screws of the cutter motor
(2) slightly.
4» Unscrew and remove both screws of the
eccentric (3).
1
2
3
5» Put the machine back to its normal position.
6» Loosen the nut on the tension pulley (4) and
release it.
7» Release both motor holders.
8» Remove the cutting belt and both transport
belts.
4
9» Mount the new belt (5) of the transport drive.
10» Mount the new belt (6) of the transport drive.
11» Mount the new belt (7) of the cutting drive.
12» Tension the tension pulley and tighten the
hex nut (4).
5
6
7
4
13» Turn the machine to the side of the wire
entry.
14» Mount the eccentric with both screws (3).
15» Screw on both motors with the screws (1) and
(2) slightly.
16» Press motor in the direction of the arrow to
tension the belts. Tighten the screws.
17» Close the housing of the machine.
1
2
3
Summary of Contents for EcoCut 3300
