6 Installation
Operating Instructions | Version 1.0 (05-2018) | Uni-M Ferrule
16 | 32
6
INSTALLATION
6.1
SETUP
WARNING
Single operator use only!
The machine has been designed for use by a single operator.
WARNING
Danger if operated by unqualified personnel!
The following operations must be performed by trained personnel only.
WARNING
Danger if adjusting with main power on!
Always turn the press’s main power switch to “Off” when making any adjustments or to the
machine or tool.
6.1.1
Confirm shut height
The shut height of the press must be set to
135.78 mm ± 0.02 mm
(5.346“± 0.0008”).
Confirm the setting is accurate with either and electronic press analyzer or a mechanical shut height gauge.
For shut height adjustment, please refer to the instruction manual of the press.
6.1.2
Install applicator in press
6.1.2.1
Mounting
1.
Release the base plate lever (1).
2.
Place the upper ram bolt (2) into the press ram
coupling (3) and lower the applicator until the
base rests on the base plate (4).
(Note: Ensure that upper ram bolt remains in the
upper ram coupling.)
3.
Lift the lever (1) to lock the applicator into
position. Firmly grasp the applicator and try to
move it to ensure it is secure.
4.
Remove the red tooling protection ring (4).
3
4
2
4
1
5
9
