February 2014
www.swstechnology.com
copyright of SLB
Pairing the Diver-Gate(M)
The following steps illustrate how to pair a Diver-Gate(M) with a Windows Mobile device to enable the Bluetooth
connection.
•
Attach the pairing dongle to the Diver-Gate(M).
•
Turn on the Diver-Gate(M).
•
Activate the Bluetooth function on a mobile device (usually found under the Settings menu) and set it to
be discoverable or visible to other devices.
•
Open the Bluetooth connection settings and start searching for nearby Bluetooth devices.
•
Remove the pairing dongle.
•
After retrieving a list of nearby Bluetooth devices, select the Diver-Gate(M) (name is
SWSGW_1414xxxxxxxx) (see example figure 1) and press Next.
•
Enter passcode “1234” and press OK (see example figure 2).
•
After the passcode is accepted, the name of the Diver-Gate(M) is displayed under disconnected devices
(see example figure 3).
•
Select Diver-Gate(M) to modify its settings.
•
Activate “Serial port” (see example figure 4).
•
The Diver-Gate(M) will automatically restart (Status LED will be continuously on for 5 to 10 seconds).
•
After approximately 30 seconds the Bluetooth LED will turn on to indicate a Bluetooth connection.
Summary of Contents for Diver-NETZ
