OPERATOR'S MANUAL
Gateway
Version: 27143
Subject to technical changes
Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
21
8 Device configuration via web interface
8.1
General information
Device settings can be configured via the web interface.
These include:
Network settings, integrate new bus subscribers, display active bus subscribers, device
information and status of the connected bus subscribers.
To access the web interface, you need the IP address that is displayed when you start the
“myfluvo®” app, see section 7.3. This IP address is entered in the browser address bar
and then this device overview opens.
Figure 10
The overview shows the possible devices to be connected.
Devices that were recognized during initialisation and are active are displayed in ( ) e.g.
converter box (1/1) LuchsNT (1/1)
If a device has been recognised but is currently inactive, this is indicated as follows:
Converter box (0/1) LuchsNT (0/1)
Inactive means that the gateway currently has no connection to the device.
Check that the device is supplied with mains voltage and that the bus line is connected.
You can access the device settings menu via
.
Here you can
teach-in bus subscribers
configure the network connection
change the app password
read out device information.