CAM Control
DOC_MAN_MEC_EFAS-CAM_#SEN_#AIN_#V1
Seite 14 von 56
Version: 2018 / 02
Unlock button
Figure5:
Uninstalling a module
1
2
3
Order of Modules in Multi EFAS Systems
NOTE
In order to ensure that the entire EFAS system works properly, arrange the EFAS modules by
their specific E-bus load, placing the modules with the highest E-bus load immediately next to
the head module (bus coupler or controller). Take account of the head module's maximum bus
load.
To snap on a single module
Push up the module against the mounting rail from below,
allowing the metal spring to snap in between mounting rail and
mounting area as illustrated.
Push the top of the module against the mounting wall until it snaps in.
To interconnect two modules
After snapping on the first module to the rail, snap on the second module about 1cm away towards
the right of the first module.
Push the second module along the rail towards the first module until you hear the locking device
snap in.
To disconnect two modules
Push down the unlock button (see Figure5) of the module that you wish to disconnect from the
module to the left of it.
Push both module away from one another until they are about 1 cm apart.
To take down a single module
1. Push the module up and against the metal spring located
on the underside of the rail guide.
2. Tip the module away from the rail as shown in the illustration.
3. Pull the module down and out of the mounting rail.
1
2
Figure 4: Rail mounting of module
