CAM Control
DOC_MAN_MEC_EFAS-CAM_#SEN_#AIN_#V1
Seite 15 von 56
Version: 2018 / 02
3.2
Ports
3.2.1
General information
The spring-assisted PUSH-IN connector
allows you to quickly attach the wires by direct insertion without
any tools. Just insert the connector sleeve end of the stripped solid or fine wire in the correct opening.
Wires:
320V / 13.4 A / 0.14 - 1.5 mm² (IEC)
Nominal current:
300 V / 9.5 A / 26 - 16 AWG
(UL)
Supported wires with connector sleeves:
Wire cross section [mm
2
]
Connector sleeve type
0.14
0.25
0.34
0.50
0.75
1
1.5
Connector sleeve w/ collar to
DIN 46228-4
8 / 10
8 / 10
8 / 10
10 / 12
12 / 14
12 / 15
Connector sleeve w/o collar to
DIN 46228-1
10 / 10
Stripped end [mm] / sleeve length [mm]
NOTE
Do not connect the power supply lines through from one EFAS to the next. To ensure that
there is as little interference as possible, install a central power supply point and
establish a star topology of as short wires as possible between the central point and
EFAS.
3.2.2
Connector for power supply and I/O
Both the system power supply and the I/Os connect to the same 36-pole module terminal block.
Figure 6: Two-row push-In connector with releasing lever
