EFAS CAM-Creator
DOC_MAN_MEC_EFAS-CAM_#SEN_#AIN_#V1
Seite 41 von 56
Version: 2018 / 02
The CAN/CAT Receiver mode apply to "Composite Mode", see chapter 7.1, middle of page, i.e. to running
several CAM modules connected to one encoder.
CAN Parameter:
Sets the node ID
You need to assign a node ID (CAN address) to the EFAS CAM Module before you can add it to a CANopen
network.
The node ID you set in this dialog will be stored in the module memory when you upload the cam program.
Enter the unit's current node ID into the box above "actual".
Enter another node ID into the box above "new".
NOTE
The set node ID will not be used until you upload the program and complete a power cycle
(turn the module off and back on again).
