EFAS CAM-Creator
DOC_MAN_MEC_EFAS-CAM_#SEN_#AIN_#V1
Seite 36 von 56
Version: 2018 / 02
6.4.2
Speed Change Scale (Control/Speed-Change-Scale)
Program change-over table
Pick Control/Options/CAM - Programs from the menu to set the number of cam programs to run
on a EFAS CAM Module.
A change between programs should occur with reference to the actual speed.
Tick the boxes in the table rows you use.
Set the speeds at which a change of program should occur.
Allocate the programs.
The picture below is just an example of the following settings:
Row 1:
At a speed of 2 or higher, the program changes from 1 to 2.
Row 2:
At a speed of 5 or higher, the program changes from 2 to 3.
If the speed drops to anything between 2 and 5, the program will go back to 2.
Please note that programs can only change in a linear manner, i.e. from 1 to 2 to 3 but not in any other way,
i.e. from 1 to 3.
