Installation manual
Page 140 of204
Remedy
Check the theory of the distance using the configured data or the
sensor setting
Check the position signal, if necessary correct the offset
Use the SCOPE function to read out the position and to set into
relation to configured values
A 3309 / A 3310
Alarm message
Plausibility fault because of faulty speed axis 1
Cause
The current speed is outside the configured maximum speed
Remedy
The drive moves outside the permissible and configured speed range
Check configuration
Use the SCOPE function to analyse the course of speed
A 3311 / A 3312
Alarm message
Configuration fault: Acceleration axis 1
Cause
The current acceleration is outside the configured acceleration range
Remedy
The drive has exceeded the permissible acceleration range
Check the configuration of maximum speed
Use the SCOPE function to analyse the course of speed/acceleration
A 3313 / A 3314
Fault message
SSI sensor fault
Cause
Encoder step change SSI-value within a cycle too big
Remedy
Check encoder wiring
Check encoder configuration
A 3318
Fault message
Incremental encoder axis 1 faulty
Cause
Track A does not match track B
Remedy
Check encoder wiring
Check encoder configuration
A 3321 / A 3322
Alarm message
Plausibility fault speed sensing axis 2
Cause
The difference between the two speed sensors is higher than the
configured speed shut-down threshold
Remedy
Check the theory of the distance once again using the data set in the
encoder configuration
Check the speed sensor
Use the SCOPE function to adjust superimposable speed signals
A 3323 / A 3324
Alarm message
Plausibility fault position sensing axis 2
Cause
The difference between the two position sensors is higher than the
configured incremental shut-down threshold
Summary of Contents for PSCBR-C-10 Series
Page 1: ...Installation manual Page 1 of204 Installation Manual For PSCBR modules Series PSCBR C 10...
Page 178: ...Installation manual Page 178 of 204...
Page 181: ...Installation manual Page 181 of 204 Example for a risk analysis Gefahrenanalyse Risk analysis...
