EN
Operating instructions pages 1 to 16
Original
SLG440
Operating instructions
Safety light grids
EN
1
1. About this document
1.1 Function
This operating instructions manual provides all the information you
need for the mounting, set-up and commissioning to ensure the safe
operation and disassembly of the safety switchgear The operating
instructions must be available in a legible condition and a complete
version in the vicinity of the device
1.2 Target group: authorised qualified personnel
All operations described in this operating instructions manual must
be carried out by trained specialist personnel, authorised by the plant
operator only
Please make sure that you have read and understood these operat-
ing instructions and that you know all applicable legislations regarding
occupational safety and accident prevention prior to installation and
putting the component into operation
The machine builder must carefully select the harmonised standards
to be complied with as well as other technical specifications for the
selection, mounting and integration of the components
1.3 Explanation of the symbols used
Information, hint, note:
This symbol is used for identifying useful additional information
Caution:
Failure to comply with this warning notice could
lead to failures or malfunctions
Warning:
Failure to comply with this warning notice could
lead to physical injury and/or damage to the machine
Content
1
11 Function 1
12
Target group: authorised qualiied personnel
13 Explanation of the symbols used 1
14 Appropriate use 2
15 General safety instructions 2
16 Warning about misuse 2
17 Exclusion of liability 2
2
21 Destination and use 2
22 Ordering code 2
23 Special versions 2
24 Scope of delivery and accessories 2
241 Accessories included in delivery 2
242 Optional accessories 2
25 Technical data 3
26 Response time (reaction time) 3
27
28 Functions 3
281 Protective mode / Automatic 4
282 Restart Interlock (operation) 4
283 Restart interlock with double acknowledgement/reset 4
284 Blanking of moving objects 5
285 Contactor control (EDM) 5
286 Rotating the display through 180 degrees 5
29 Self-test 5
210 Beam coding A 5
211 Parameter setting 6
3
31 General conditions 7
32
33 Alignment of the sensors 7
34 Setting mode 8
35 Safety distance 8
351
Minimum distance to relecting surfaces
36 Dimensions transmitter and receiver 10
37 Fixing 10
4
41 Wiring example 12
42 Wiring example SLG440 13
43
Connector coniguration Receiver, Transmitter & Cable
5
51 Check before start-up 13
52 Maintenance 13
53 Regular check 14
54 Half-yearly inspection 14
55 Cleaning 14
6
61 Status information LED 14
62 Fault diagnostic 15
7
71 Disassembly 15
72 Disposal 15
8
81 Contact 15
9
Version 2.0
x000 / 032016 / v
A - 101217024-EN / E / 2016-03-10 /
AE-Nr
5854
