Xact Small Tank Monitoring System
9
Calibration
Confirm the calculated tank capacity displayed at the bottom is
reasonable. This is the exact tank water capacity according to the
dimensions you entered earlier. This may vary slightly from the tank
manufacturers name plate. If you feel this is incorrect, push the back
button on your device to verify your measurements.
In order for the Xact Tank Monitoring System to more accurately
calibrate to the tank, some information is helpful. Enter the approximate
fill level of the tank.
Once you have entered this information tap on the
Begin
Calibration
button to continue. If you don’t have this information
check the box next
to
Fill level unknown
then tap on the
Begin Calibration
button.
Based on the information you provided in the previous steps, the Xact
System will perform a calibration cycle that sets the Xact Sensor for optimal
performance for the individual tank.
Progress of the Calibration is indicated by the bar, and should complete
in about 2-6 minutes. The application indicates if the calibration cycle was
successful or not by displaying the appropriate screen.
If the cycle is unable to calibrate, or if you receive an error message, see
the troubleshooting section of this manual for further assistance.
Upon a successful calibration, select
Finish
. Xact Small Tank Monitoring
System will now establish communications with the satellite system and
transfer the information to the web site. This process can take up to 45
minutes, depending on satellite location. DO NOT UNPLUG THE BATTERY.
Remove the Bluetooth adapter, retrieve the 2
”
plug that you set aside
earlier, and firmly insert it into the hole in the bottom plate of the Satellite
Box. Ensure this is completely seated and flip the box right side up.
While the system is completing the process of sending setup information,
you should immediately proceed to finish the installation of the hardware.
Summary of Contents for Xact
Page 6: ......