Schneider Airsystems A202002 Original Operating Manual Download

Page: 10 / 68

I/2

UNM Base / CPM Base

Table of contents - Part 1

1.1 Scope of delivery

A202002 / A211002 / A212002 / A711002 /

A711003:
– Compressor with instruction manual
A213002 / A214002 / A712002 / A712012 /

A713002 / A714002 / A715002 / A715102:
– Compressor with instruction manual
– Documents accompanying compressed air

vessel

1.2 Conventional use

The compressor is designed for generating

and storing compressed air only. Com-

pressed air is only suitable for compressed

air tools/devices/machines.
Any other type of use is considered contrary

to the intended use.
The compressor must

not

be used in poten-

tially explosive areas. Combustible, caustic

or toxic gases must

not

be sucked in!

1.3 Technical data

see Fig. 1a

1.4 Components

1.5 Maintenance

1.5.1 Cleaning the intake filter

1. Unscrew the intake filter. (Fig. 5a)
2. Clean the filter insert using the blow gun,

exchange the filter insert if necessary.

3. Screw the intake filter back on.
A711003:
1. Loosen the screws and open the housing

as shown in Fig. 5a.

2. Pull out the filter insert (Fig. 5a).
3. Clean the filter insert using the blow gun,

exchange the filter insert if necessary.

4. Insert the filter insert.
5. Close the housing and tighten the

screws.

1.6 Vessel inspections

A202002 / A211002 / A212002 / A711002 /

A711003:

No inspections are specified for the ves-

sels.

We recommend that a "qualified person" per-

form a pressure test on the vessel, depend-

ing on its rate of utilisation, after 10 years in

accordance with the Ordinance on Industrial

Safety and Health. Contact any of our service

partners.



The statutory specified inspections must

be arranged in accordance with the appli-

cable regulations of the respective coun-

try in which the vessel is used.

A213002 / A214002 / A712002 / A712012 /

A713002 / A714002 / A715002 / A715102:
Compressor with type test:

Inspection is

not required prior to commissioning.

Type identification: see compressor type

plate
We recommend that a "qualified person" per-

form a pressure test on the vessel, depend-

ing on its rate of utilisation, after 10 years in

accordance with the Ordinance on Industrial

Safety and Health. Contact any of our service

partners.



It is essential to retain vessel documents

included in the delivery (= certification

documents) for the entire service life of

the vessel. The statutory specified inspec-

tions must be arranged in accordance

with the applicable regulations of the re-

spective country in which the vessel is

used.

1.1

Scope of delivery ......................

1.2

Conventional use ......................

1.3

Technical data ..........................

1.4

Components.............................

1.5

Maintenance.............................

1.6

Vessel inspections .....................

01 Compressor unit
02 Intake filter
03 Oil dipstick
04 Oil drain screw
06 Pressure pipe
07 Check valve
08 Vessel
09 Condensate drain valve
10 Pressure switch with ON/OFF switch
11 Safety valve
12 Pressure gauge (vessel pressure)
13 Pressure gauge (working pressure)
14 Electric motor
16 V-belt
17 Belt guard grating
18 Pressure reducer
19 Quick-action coupling