I/2
GB Universal 170-25 W
01 Compressor unit
02 Intake filter
03 Oil dipstick
04 Oil drain screw
06 Pressure pipe
07 Check valve
08 Vessel
09 Condensate drain valve
10 Pressure switch with ON/OFF switch
11 Safety valve
12 Pressure gauge (vessel pressure)
13 Pressure gauge (working pressure)
14 Electric motor
18 Pressure reducer
19 Quick-action coupling (clean, regu-
lated compressed air)
Table of contents - Part 1
1.2 Conventional use
The compressor is designed for generating
and storing compressed air only. Com-
pressed air is only suitable for compressed
air tools/devices/machines.
Any other type of use is considered contrary
to the intended use.
The compressor must
not
be used in poten-
tially explosive areas. Combustible, caustic
or toxic gases must
not
be sucked in!
1.3 Technical data
see Fig. 1a
1.4 Components
1.1
Scope of delivery ......................
2
1.2
Conventional use ......................
2
1.3
Technical data ..........................
2
1.4
Components.............................
2
1.5
Adjusting the working pressure...
2
1.6
Maintenance.............................
2
1.7
Vessel inspections .....................
2
1.5 Adjusting the working pres-
sure
Rotate clockwise = pressure is increased.
Rotate anticlockwise = pressure is reduced
(Fig. 9a).
1.6 Maintenance
1.6.1 Cleaning the intake filter
1. Loosen the screws and open the housing
as shown in Fig. 5a.
2. Pull out the filter insert (Fig. 5a).
3. Clean the filter insert using the blow gun,
exchange the filter insert if necessary.
4. Insert the filter insert.
5. Close the housing and tighten the
screws.
1.
7
Vessel inspections
An informal inspection book (collection of all
documents related to the vessel including in-
spection documents from the "approved test
centre") must be compiled for the vessel.
Register the vessel
with an "approved test
centre", stating this data. The centre initiates
and certifies
an installation check by an
authorised expert
and specifies the inter-
vals for repeat inspections.
It is essential to retain vessel documents
included in the delivery (= certification
documents) and inspection documents for
the entire service life of the vessel. The
statutory specified inspections must be
arranged in accordance with the applica-
ble regulations of the respective country
in which the vessel is used.
1.1 Scope of delivery
– Compressor with instruction manual
– Documents accompanying compressed air
vessel
Summary of Contents for Universal 170-25 W
Page 3: ...5a 6a 02 7a max min 9a...
Page 4: ......
